1. Sit the device on floorboard of car.
2. Place roller in middle of right accelerator.
3. Check distance on left foot accelerator.
(Be sure it is not too close to brake. If so, use wrench to adjust). Also make sure that you can activate emergency brake freely.
Before each use:
Be sure the left foot accelerator is properly adjusted to each individuals fit.
Inspect device prior to every operation.
Be sure nothing is obstructing the left foot accelerator. Inspect device prior to every operation.
Keep floorboard clean of debris such as rocks, dirt, ice, etc.
Caution:
Do not sit on top of rubber floor. Carpet Only!
Do not use right accelerator guard as footrest.
For use with automatic transmissions only.
Works better with most vehicles without the floor mat, but not always.
Initial Position
ADJUSTING
Initial Positioning
A 3/16” (approx.) gap should be visable between the flat part of the
actuator arm assembly and the gas pedal.
Front to Back
The adjustable slide of the actuator arm should be parallel with the
gas pedal.
Actuator Arm Adjustment
For gas pedals with a pivot: The roller should be located above and
close to the pivot (roller must not be located even with, or below the
gas pedal pivot point.)
For solid gas pedals (no-pivot), the roller should be located between
the top 1/2 and 3/4 of the gas pedal.
Wrench size: 7/16”
1/8” screw key (Allen wrench)
1/4″ screw key (Allen wrench)